Car won't start after wiring accident
#1
Car won't start after wiring accident
2005 G35 coupe...Before I start I want to admit my stupidity up front, however, if anyone can help i would appreciate it. I was running a speaker wire through the firewall boot on the drivers side of car. Had a knife through the boot, pulled the knife out and was going to put back through to make hole bigger, but when I was putting knife through I must of hit a wire and the engine began to crank. I immediately pulled knife out and engine stopped cranking. I then put key in ignition and tried to start car, everything works and engine turns over, but will not start. I suspect that the security system is preventing me from starting car, but cant figure out how to override...please help!
#3
Any updates on this?
I would doubt it would be the OEM security, I would assume you've cut injector/ignition/sensor wires.
Sticking knife through a firewall? That's a new one. Thexton actually makes an $8 wire insertion tool that is perfect for poking through grommets without taking out any wires on the other side.
I would doubt it would be the OEM security, I would assume you've cut injector/ignition/sensor wires.
Sticking knife through a firewall? That's a new one. Thexton actually makes an $8 wire insertion tool that is perfect for poking through grommets without taking out any wires on the other side.
Thread
Thread Starter
Forum
Replies
Last Post
Hasanbaloch
Engine, Drivetrain & Forced-Induction
15
02-29-2024 08:45 PM
Bean_VQ35DE
Engine, Drivetrain & Forced-Induction
49
08-03-2015 05:17 PM