I'm about to install my diamond audio hex's and was wondering where i should install the passive xover and also should i run new wires or is it possible to use the factory wires..... if anyone has done this type of install please share your experience.....thanks

 

As far as I know diamonds have big crossovers , so if you can find a place for them on front that is fine otherwise I would mount crossovers in the trunk and run new set of wires to for mid and tweeter , plus they need good amount of power to run properly so new wires would help.

 

i'm gonna mount the crossovers in the trunk but i'm having a problem getting the wires ran in from the door to the car.... can anyone help here ...... it a real pain... never had so much trouble before.... thanks for the help guys

 

why not put them in the kick panels by the door

 

No space to mount them on the door somewhere under the doorpanel?

 

I don't know how big your passive xover is but this is where I mounted the Infinity 6000 Ref series xover on my door...........hope this helps

 

my xover is huge....i just mounted it next to the amps so i can adjust it also...
thanks for the help...