DLS UP6 Comps./ JL e6450 amp./ JL10w3v2d4 sub/ how to wire?
#1
DLS UP6 Comps./ JL e6450 amp./ JL10w3v2d4 sub/ how to wire?
Hello,
I would like to bridge all six channels of the amp. in order to get 220 w to each of the components (2) and the subwoofer (1). The problem that I see is that the amp. can only be bridged at 4 ohms min. and I think the sub. would give a 2 ohms load running in paralell.
What do you think I should do?
Any help would be very welcome.....
I live in Santo Domingo, D. R., please excuse my English,
Thanks,
Carlos
I would like to bridge all six channels of the amp. in order to get 220 w to each of the components (2) and the subwoofer (1). The problem that I see is that the amp. can only be bridged at 4 ohms min. and I think the sub. would give a 2 ohms load running in paralell.
What do you think I should do?
Any help would be very welcome.....
I live in Santo Domingo, D. R., please excuse my English,
Thanks,
Carlos
#2
Thread
Thread Starter
Forum
Replies
Last Post
Ninjay16
Audio/Video/Electronics
11
02-26-2018 06:14 PM