How about some pics of the back, or the wires in the back.. I am doing my install next week and would like to get some ideas.. and just how much glovebox removal I have to do and just where to run the wires..

also pics of the inverter location and wires?

 

here are the pics of the hole in my glove box.

i just went and bought a dc power supply from ebgames so i didnt need an invertor. i currently have it hooked up to the cig lighter but need to put it on a constant power source so it doesnt turn off when i turn the car off or go from on to acc.

 

in the middle pic you see the gray thing right above the black line. that is the reason why i had to make the hole so big. if i just cut out the section big enough for the round part to go through on the av connector, then when i put the ps2 in and tried to push the cables back the round part would hit that and not let it slide back far enough. when i made the hole bigger the round part can now slide sideways so the ps can go all the way in and shut with the controller connected.


has anyone found a short memory card. the standard memory cards from sont are about a half inch too long and hits the roof of the glove box not allowing it to shut. does any one know of any aftermarket ones that are shorter??

 

Hmm.. this DC powersupply? Is this not an inverter? I have a small 75watt inverter that plugs into the cig lighter, but I am going to hard wire it..also where is your switch (if you have the tvandnavtogo).

 

how much is that Avic-D1

 

dont have the tv nav to go, i dont have navi. i just plugged it into the input for my kenwood.

mine kinda looked like this but i got it at ebgames.
http://cgi.ebay.com/INTEC-G7690-PS2-Slim-Car-Adapter_W0QQitemZ8269781321QQcategoryZ41059QQrdZ1QQcmdZViewItem
i just took it apart and directly connected it to the cigarette lighter.