if you look at these rotors these have more holes in them than any other rotors i've seen...i've searched and searched and couldnt find these same exact setup for my stock brembo's

 

Sorry to thread jack but is there anymore pics of this G? I been looking for a G on tri-star rims.

 

Kinda looks like this one? It's our AeroRotor direct replacement for Brembo G35 and 350z's. The front rotors are almost 3 lbs lighter than stock.

 

are these rotors pretty good?....i've never heard of them...and where can i buy them? thanks

 

i'll post more pics when i come back from nashville in a couple of hours

 

actually i found out who sells it creative autoworks...thanks!

 

man...that's a lot of holes....

 

StopTech AeroRotors are actually sought after by many enthusiasts. Our patented rotor design flows more air keeping the brake cooler.

The only investment that you have to make is the initial purchase of the rotors. Then in the future, all you would do is replace the outside friction rings which are the same cost as the one piece Stoptech slotted rotors(which are heavier, and don't flow as much air.)

The rotors were used on the Unitech 350z race team when they had to use the stock brembo brakes. The parts are available through most of G35driver forum sponsors. And incase you are wondering, there are about 144 holes.

 

anything from stoptech is GOOD

 

<hijack> wtf, where is the bumper for that car? </hijack>

 

Yes, Stoptech is very good!!

 

I wonder if the the are available for an 04 non brembo

 

They are in the form of a big brake kit. If you are just looking for slotted or drilled rotors, we have one piece rotors w/ a similar look for the non-brembo.

 

how much are those?