Stillen STB WITH the engine cover
#17
#18
Yes, I have the 5/16" spacer with an MREV+. The bar barely clears the top of the plenum by a couple mm. Just to be safe, I cut a couple squares of rubber and stuck them to the bottom of the bar and those made contact. With the Stillen engine stabilizer, the engine does not move so it's no problem. I didn't use any spacers to mount the bar.
The engine cover does not fit under the bar, even without a spacer. That is why I cut a space out of it so the bar goes through it. Look at my pic in my first post very closely. The bar is almost flush.
The engine cover does not fit under the bar, even without a spacer. That is why I cut a space out of it so the bar goes through it. Look at my pic in my first post very closely. The bar is almost flush.
Last edited by The_Scooch; 08-08-2007 at 03:46 PM. Reason: missed a word
#21
Stillen brake master cylinder brace
Yo the strut bar you installed, do you know if you are able to install a Stillen Master Cylinder Brace together with the strut bar you installed
Thread
Thread Starter
Forum
Replies
Last Post
joedaddy1
Engine, Drivetrain & Forced-Induction
0
07-28-2015 02:58 PM