I've compared the two pictures. I'll stick with my set-up.

Thanks for the picture.

 

Hey Scooch, any plenum spacer installed as well? I see Motordyne in your sig.

Curious if 5/16 AND engine cover will fit uner the Stillen bar.

Also, did you have to use and spacers for the strut bar itself to raise it?

 

Yes, I have the 5/16" spacer with an MREV+. The bar barely clears the top of the plenum by a couple mm. Just to be safe, I cut a couple squares of rubber and stuck them to the bottom of the bar and those made contact. With the Stillen engine stabilizer, the engine does not move so it's no problem. I didn't use any spacers to mount the bar.

The engine cover does not fit under the bar, even without a spacer. That is why I cut a space out of it so the bar goes through it. Look at my pic in my first post very closely. The bar is almost flush.

 

Cool, I lost my spacers that came with my Motordyne and plan on getting the stillen fr strut bar, good to know i wont need them.

 

Here you go. Very level with the spring mount mod...

 

Yo the strut bar you installed, do you know if you are able to install a Stillen Master Cylinder Brace together with the strut bar you installed