how do I adjust the rear d-specs ?
you have to pull them off. they adjust at the same location as the fronts, on top. you can get extensions so that you can adjust them from the inside of the car
Last edited by EL-EE-ES; Aug 2, 2008 at 01:47 AM.
raise one side of the rear, remove the rear wheel.
remove the two nuts at the top mounts (rear shocks) and pull the
mounts down and hold.
remove the protective cap, fit the 3mm d-spec adjustment tool, turn,
put cap back on, let the shock extend by itself into place, and tighten
the nuts snug, but not super tight.
do the other side.
im at 1.5 turns from full stiff front, 2.5 on the rear. feels good.
remove the two nuts at the top mounts (rear shocks) and pull the
mounts down and hold.
remove the protective cap, fit the 3mm d-spec adjustment tool, turn,
put cap back on, let the shock extend by itself into place, and tighten
the nuts snug, but not super tight.
do the other side.
im at 1.5 turns from full stiff front, 2.5 on the rear. feels good.
Thread
Thread Starter
Forum
Replies
Last Post
netcbc
Steering & Suspension CDN
0
Jul 24, 2015 01:59 PM
netcbc
Steering & Suspension CDN
0
Jul 24, 2015 11:25 AM



