911- Need some help guys - broken Brembo bleeder
#1
911- Need some help guys - broken Brembo bleeder
So...it's a DIY gone terribly wrong
Putting the car away for the winter, started to change the brake fluid. Got to the front caliper - tried to loosen the bleeder valve and SNAP. It breaks right off. Not sure how this happened, I just changed my brake fluid a few months ago and didn't tighten them that hard. Man - this sucks.
So...what do I do now? Do I try to drill it out and use an Easy Out? Do I drill it out completly and use a Heli-Coil to re-tap the thread? Need some suggestions please...
Putting the car away for the winter, started to change the brake fluid. Got to the front caliper - tried to loosen the bleeder valve and SNAP. It breaks right off. Not sure how this happened, I just changed my brake fluid a few months ago and didn't tighten them that hard. Man - this sucks.
So...what do I do now? Do I try to drill it out and use an Easy Out? Do I drill it out completly and use a Heli-Coil to re-tap the thread? Need some suggestions please...
#2
Registered User
iTrader: (85)
I would try to use an easy out first to see if you can get it out. Only re-tap if you need too/have too.
There's a hole right down the middle already so an easy out might do the trick. If you are not comfortable doing it yourself, I w ould suggest taking the caliper off and having a mechanic do it for you.
There's a hole right down the middle already so an easy out might do the trick. If you are not comfortable doing it yourself, I w ould suggest taking the caliper off and having a mechanic do it for you.
Thread
Thread Starter
Forum
Replies
Last Post
bTanz
G35 Coupe V35 2003 - 07
16
10-15-2015 02:31 PM
Nick_M
Interior & Exterior
1
08-03-2015 11:08 PM
Nick_M
Interior & Exterior
0
08-03-2015 05:33 PM