I purchased a Echiba rear camber kit with toe bolts. The only problem is it didnt come with the template to elongate the toe bolt hole. I was wondering if anyone would be willing to mail me theirs or if there is a website I can download it from. An spc template will work for this as well.

Thanks for the help,
Casey

bump

I think I might still have one, If I do I can fax it to you.

That would be great if you had one. Is there any any way you could email it to me. I dont have access to a fax.

Thanks

PM me your e-mail if you didn't get the template already. I'll scan it to you.

I also need this template. My email is Drowe303@yahoo.com if anyone wants to send it over

+1. I need one as well. HenryLee@ufl.edu

You pretty much just need to elongate the current hole so the toe bolt can fully turn within the frame (for maximum adjustment). Using a Dremel with a metal cutting bit will work perfectly.

Here's the one I sent to the OP.

I need this too , thanks!

Appreciate you sharing this. Saved me $40 bucks!

Here is a good write up on the toe bolt install if anyone needed it.
http://batit.com/forumpics/spctoeboltinstall.pdf