hi i recently installed the rear camber arms on my 05 coupe and took it in for a allingment i told the guy that he needed to dremel out the hole a little so he could install the toe bolts he said no prob, when i went to pic my car up he said i didnt need the spc toe bolts that the factory ones were good enough he said that my specs were very good close to factory and i didnt need them can anyone shed some light on this thanks allot btw im dropped on g35 tein s techs

 

anyone?

 

If the shop was able to get you back into spec you don't need to install them.

 

The only time you will need them is if you can not bring your toe back to spec. Since the shop was able to bring your toe back to spec than I wouldn't worry about it. BTW did you get a print out of your before and and after specs.

 

Did he say it was within factory spec or close to being within factory spec? If it's close to..i'd be on the safe side and have them install it and get it within factory spec. If it's within spec, no need to install.

 

yes i got a printout my rear camber is (left)(before -2.1) (after -1.7)
(right) (before -2.0)(after 0.9) and my toe is (left) (before 13/32") (after 3/32")
(right)(before 3/32")(after 1/32") (total before =1/2")(after total=1/8") im not to sure about the toe specs!but he said they were within spec any input would be much apreciated thanks in advance!

 

yes i got a printout my rear camber is (left)(before -2.1) (after -1.7)
(right) (before -2.0)(after 0.9) and my toe is (left) (before 13/32") (after 3/32")
(right)(before 3/32")(after 1/32") (total before =1/2")(after total=1/8") im not to sure about the toe specs!but he said they were within spec any input would be much apreciated thanks in advance!