I just got 350z H&R springs and I want to put spacers on my stock 18s to make them sit flush. I will need 25mm spacers in the front and 30mm spacers in the rear, correct?

Will I have to roll my fenders with that set up? What if I went with 15mm spacer up front and a 20mm spacer in the rear? How close to flush will I be and then will I need to still roll my fender?

Thanks in advanced.

 

Anyone?

 

whats the drop on the H&R? With the 350Z eibach prokit, the 25mm fit the rear without rolling the fender. 30mm in the rear rubbed, had to roll the fenders. Thats on about a 1.5inch drop. If you dont want to roll the fenders stick with 25 in the rear, but the 30mm sits perfect. I would run the 25 up front too. 15 up front is no where near flush.