Hey folks,

I ordered everything for my setup for 06 Coupe and have started the installation process. I've gotten the coilovers installed and was going to install the A-arms and the rear camber arms but I ran into some issues.

I had already resolved the A-arm issues by reading one of the write ups I found in my search on this site.

However, I still have an issue with the rear arms and I could not find any solution.

My situation is this: I am trying to install the arm and the bushing on the arm seems to be took big and is bending the bracket (the one that the bushing is supposed to be sliding into) outwards.

Is this a normal issue? If not, how would I go about resolving this issue?

Thanks guys!

 

As long as the bushing is new and centered in the head of the camber arm you're OK. I had to widen that bracket a little to fit my Stillen arms in there so don't worry, just do it.