These seem like a great price for a front and rear camber. I've had a huge problem with tire wear when I lowered my car. Will this fix the problem alone, or do I need to get anything else?

http://www.kinetixracing.com/index.a...&ProdID=8&HS=1

 

What happens to the coil spring lower mount (cup) when you put the Kinetix traction arms on?

Isn't that part of what gets replaced when you install the traction bar?

 

that set looks good.

 

After looking at the Service Manual again, it appears that Kinetix means to replace the control rod with their traction arm, not the rear lower link. My bad, but they don't spell out where it goes in their documentation.

 

I had the Kinetix camber arms on my old 350, and they were great! I put them on myself and never had any problems with them. One word of advice, dont try to do the alignment yourself, it was quite a task driving my Z to get aligned, the back end was going everywhere.

 

hey when u did the install did u jus not use the cone thing that goes into the spindle cuz i did mine today and jus put the bolt through and tighened it up good but other control arms it says to pull the cone thing off the old arms and use it but it wouldnt fit?