I F'*&* hate it.

Can't seem to avoid this ****, just found 1 on each side of my G.

It bothers me, and i wanna get it fixed.

Any recommendations..?

Autodent Magician not sure the name, any1 heard of them

 

I used the Dent Dr. on Doncaster in Thornhill a few years ago.
& IIRC there's another one or two buried in here if you want to play detective.

 

north of steeles of yonge to the right... boi, let me know where you go, take some before and afters, i have two dents on the rear quarter pannel that id like to take car of come mid-april.

 

There was a dent clinic hosted by ?????? SK preformance ???? at a shop off Dixie, south of the 401. I dropped by and he did good work. I don't recall his address but I believe Gordon was there. I'll try to look up the posts.

 

Here ya go.

https://g35driver.com/forums/canada/...ssissauga.html

 

Yup, I was there, did a fantastic job of removing all the hail damage on my car. Here's his contact information; he's works out of a shop next to Tires23 near Matheson and Dixie and he is mobile as well.

Dent Xpress
Thilan Leanage
416.220.1921
dentxpress@hotmail.com

Tell "T" that Gordon sent you...

 

^ +1 for Dent Xpress. They fixed a nasty door ding on my G. You can't tell it was dinged no matter how close you look.

 

do they charge for how much dents they fix?

 

You would have to bring your car in to get a proper quote. Basically charges a rate for the 1st dent on a panel and then a reduced rate for all other subsequent dings on the same panel.

 

i wish someone has before and after pictures, i dont know what should i do with mine!!!!

my car has driver side door part where the door has a wavy look now, it seems like when the stupid cab crashed(i was at the club), the metal went in than out, so its like a wavy texture, do you think I have chance with the dent removal.

 

If you are located in the KW area by neighbour does this out of his garage i could ask him to hook you up.

He works at an auto assembly plant in and this is his full time job...so he's very good at it...