anybody knows how to do this? does it have screws just like the infiniti G35 word? let me know thanks....

 

It's glued on with 3M emblem adhesive tape. You can remove by using fishing line or dental floss behind the item to cut it from the glue. Helps if the car has been in the sun for a while. Get as close to the paint as you can without scratching along it.

Now you'll be left with black adhesive in the shape of the emblem. Dab it with Goo Gone and let it soak into the adhesive. ONLY USE A 100% USA, MADE-IN-THE-USA COTTON towel or other safe cloth for washing/waxing your paint. Repeated applications of the Goo Gone will be needed. Patience! The adhesive might only come off a bit at a time, forcing you to go through the Goo Gone / rubbing steps 3-5 times.

Wash area and wax spot for good measure.

 

infiniti writing in the center is just 3M but i think the infiniti symbol itself has holes

 

thanks.. I was able to remove the infiniti word and g35 so easily.. but for the emblem.. yes I think there will be holes.. does it have to be done in a shop?

 

You can also use a hair dryer to heat up the adhesive, then it comes off a bit easier. I am not sure if there is anything besides the tape on the emblem, as I only took off the lettering.

 

I'm pretty sure it's all held on by the adhesive...no holes.

 

IIRC...
Sedan = holes
Coupe = No holes

 

I have a 2005 coupe.. so no holes?

 

No holes on any of the badging on the back of an '03 coupe. Removed all of mine with a hairdryer and a driver's license.

 

yup, no holes for coupes

 

What i'm curious about is the FRONT emblem. The rear shouldn't be a problem. I'm suppose to be receiving my new front and rear black Infiniti(via Infiniti-parts.com) emblems today and I have no idea how to replace the front emblem!I've only seen it installed on an '03 brilliant silver coupe and looked sweet. Hopefully it comes w/ installation instructions otherwise, any advice or guidance on this project would help.

 

Can't remember if the tabs are on the sides or above and below (must be the sides), but you'll press the release tabs on the sides of the emblem and then slide it straight out. It's not just a flat emblem, but rather a cup-like module. the new one should slip and click into place. The front is the easy one.

 

Good lookin' out GT-Ron! Ill let u guys know how it goes and try to post pics.

 

Yeah, for the front one just pop the hood and reach in behind your grill, you will see two clips on the sides, they pop out super easy.

 

yea its jst 3m tape, its really sticky though. I originally jst did the infiniti and g35 and left the emblem on for a little. And then i wanted to clean it up and jst took it off.

yea the coupe doesnt have holes, but the sedan does jst to clarify