[DFW] What have you done to your G Today?
Former G35driver Vendor
iTrader: (15)
Going to Look Sik Blake and I get to see it first..LOL
The lower plenum will start out chrome PC then Copper.. Gonna be an amazing contrast is what Law is telling me
i wouldn't...my brother and I already had a little "incident" in his car on the tollway.
Berks Install & Nissan Parts Dept.
This is what I did Saturday AM, installed BERK'S HFCs and used new OE gaskets I purchased from Nissan which was a PIA. I didn't want to use the old gaskets cause I didn't want any unwanted noise. We all assume the Z and G are the same but not according to their parts department computer. The top of the cats are a 3 bolt flange, there's only shows a 2 bolt. And where they show the top is actually the correct gasket for the bottom of the cat....nightmare! I pissed off the parts manager and made him match up the gaskets so I'd get the right ones. Then he tried to charge me $19 each for the gaskets. I pulled my normal response to getting screwed and asked him if I had STUPID written on my forehead. Ended up paying $42 for the set but the insurance of no unwanted noise was worth the cost. Just one of Gary's normal Saturday mornings....
Gary
Gary
This is what I did Saturday AM, installed BERK'S HFCs and used new OE gaskets I purchased from Nissan which was a PIA. I didn't want to use the old gaskets cause I didn't want any unwanted noise. We all assume the Z and G are the same but not according to their parts department computer. The top of the cats are a 3 bolt flange, there's only shows a 2 bolt. And where they show the top is actually the correct gasket for the bottom of the cat....nightmare! I pissed off the parts manager and made him match up the gaskets so I'd get the right ones. Then he tried to charge me $19 each for the gaskets. I pulled my normal response to getting screwed and asked him if I had STUPID written on my forehead. Ended up paying $42 for the set but the insurance of no unwanted noise was worth the cost. Just one of Gary's normal Saturday mornings....
Gary
Gary
This is what I did Saturday AM, installed BERK'S HFCs and used new OE gaskets I purchased from Nissan which was a PIA. I didn't want to use the old gaskets cause I didn't want any unwanted noise. We all assume the Z and G are the same but not according to their parts department computer. The top of the cats are a 3 bolt flange, there's only shows a 2 bolt. And where they show the top is actually the correct gasket for the bottom of the cat....nightmare! I pissed off the parts manager and made him match up the gaskets so I'd get the right ones. Then he tried to charge me $19 each for the gaskets. I pulled my normal response to getting screwed and asked him if I had STUPID written on my forehead. Ended up paying $42 for the set but the insurance of no unwanted noise was worth the cost. Just one of Gary's normal Saturday mornings....
Gary
Gary
Hey man, Im trying to get these also. Did you feel any gains?