^Did you clean all the carbon build up on the piece that comes out and spins. It has copper wires on it and is copper all around. the carbon gets build up so bad on there i usually hit it with electrical cleaner and use a grey scotchbrite pad to get the carbon off

Yep, I cleaned everything. It is completely dead. When I push the button I can hear the relay sending the signal, but the motor is pretty much completely dead. The window will not move at all.

Yup he sure did. It looked pretty much brand new when we put it back together.

That's insteresting. I have put one back together and it was binding up. Took it back apart and redid it and it worked. It could be dead though

Ha, I knew brit wouldn't do it by himself. Lol just messin with ya brit.
Intstalled and clutch and tranny today with gshadys assistance. My lift and tranny jack worked like a charm. Too bad the slave cylinder is wasted

Roy's?

Yea I have done two before and had good luck with both. The commutator had a lot of built up grime on it. It didn't look like dirt either. I think from him trying to use it several times with it gummed up it has fried it.

Oh well thankfully they are cheap to replace.

In for the best place to buy window motors from as well. I've cleaned my driver side several times, and its just not working anymore. Time for a new one.

Tony at fontana should be able to hook it up. Tim at grubbs might as well

Ordered new wheels this past week.

Should be here by end of August.

what did you order?

A set of 3-piece forged wheels that I got a real good deal on.

Edafe took too long to get back to me on a price of DPE's. Tony was kind enough to point me in the direction of someone who he's been talking to about getting wheels from, just in case his Venaci wheels didn't come in.

hmmm...I think I know who it is

all your avatars are awesome. i'm changing mine.