[DFW] What have you done to your G Today?
I am doing it for piece of mind more than anything. Everything I read mentioned the rear camber arms to dial in the rear camber after the drop so you don't go through your tires so fast.
My current ride height is as low as I can go before I start scraping getting into my driveway.
I did buy front SPL arms since I wanted adjustable camber/caster which the factory doesn't provide.
I tried installing my new NRG hood dampers tonight and the hood will close fine, but when I try to open the hood it starts to hit my fenders at the corner and makes a POP noise and is starting to chip away at the paint already. I am just not going to open it until I know what to do to fix this lol.
I also noticed that the hood is a little off center and thats why it is rubbing so bad on one particular side. I have bent the joint toward the front of the car at a pretty good angle as well.
If anyone has any suggestions please send them my way. Im worried the chipping of the paint is going to get really bad if I keep opening and closing the hood so I might just take the thing over to Stephen and have him fix it in one go... Thanks for any help guys
I also noticed that the hood is a little off center and thats why it is rubbing so bad on one particular side. I have bent the joint toward the front of the car at a pretty good angle as well.
If anyone has any suggestions please send them my way. Im worried the chipping of the paint is going to get really bad if I keep opening and closing the hood so I might just take the thing over to Stephen and have him fix it in one go... Thanks for any help guys
don't bend!!!!! (eek)
Best idea is to simply loosen the bolts where the hood bolts to the hinges and just adjust that way. You'd be surprised how much play there is when just loosening those bolts and then tightening them back up. When I installed my CF hood a long time ago I spent almost 45 mins adjusting that damn thing. Body panels suck to line up!
Best idea is to simply loosen the bolts where the hood bolts to the hinges and just adjust that way. You'd be surprised how much play there is when just loosening those bolts and then tightening them back up. When I installed my CF hood a long time ago I spent almost 45 mins adjusting that damn thing. Body panels suck to line up!
The following 2 users liked this post by BlueBOB:
Frankieg35 (12-30-2011),
g35man04 (12-29-2011)