[DFW] What have you done to your G Today?
The following users liked this post:
JaE35 (02-05-2012)
The following users liked this post:
g35man04 (02-07-2012)
hoping to get funds in full over in the next few days to BH so we can get the motor built and finished up as well as bolted to the tranny so we can ensure everything is ready to go...getting car to stephen at the end of the week to pull the motor and tranny, weld up holes and paint engine bay then end of the weekend trailer over to BH for the final stages!
hoping by the middle of MARCH we should be running. everything will be stainless lines and AN Fittings that can have them.
hoping by the middle of MARCH we should be running. everything will be stainless lines and AN Fittings that can have them.
multiple different things but whenever you dont run fender liners, your BCM isnt placed in the factory location, you add you being lowered and it pouring down rain you will fry alot of electrical components and thats what happened with ROY's car.
you have to understand that your BCM controls all of your fuses within your car on the drivers side interior kick panel by the e-brake piece for Autos.....anything electrical in the engine bay that is exposed to water and such like roys in the evening it basically just fry's every bit of that and its a $500.00 piece to replace at one of the cheapest to find.
you have to understand that your BCM controls all of your fuses within your car on the drivers side interior kick panel by the e-brake piece for Autos.....anything electrical in the engine bay that is exposed to water and such like roys in the evening it basically just fry's every bit of that and its a $500.00 piece to replace at one of the cheapest to find.