I have been reading up on this, but have not found a clear answer on here or on my350z. I have the aem ugeo wide band guage installed, now I want to data log with it so that I can adjust some parameters with the utec. On the back of the aem guage there is a wire for the data.

I have read that the only wideband guage that intagrates seamless is the turboxs wideband. My question what secondary application or connection do i need to get to get this to work.

any input is appreciated thanks
Danny

 

you have to solder a serial port (db9) connector to the AEM wiring (its all in the instructions). Then you have to purchase UTI or another logging program that syncs the UTEC and the wideband.

Very easy.

 

ya I was just reading about making this cable, doesn't sound to bad. Do you use the software UTI? if so how do u like it?