thanks guys. Good to hear from you Sean and Dave

 

Nice work dude!

 

cool cool

 

bump

 

Great work.Mike you ever going to finish your car?

 

Is there any DIY for Wiretuck?

 

Found some pix that i took during the side wire harnesses tuck

 

Everything removed so i can tuck the side harnesses.



Removed front bumper, grill, front wheels, wheel well liners, battery covers, under engine plastic shroud, Windshield wiper funnel, Coolant overflow, hood sensor bracket, etc...

 

Disconnected everything from the side wire harnesses. Labeling both ends of the connects so nothing gets mixed up.

 

looking good man.

 

Routed disconnected side wire harnesses through side hole hidden in Battery compartment and in Brake compartment. In battery compartment, hole is hidden behind the "3 wire harness plug holder". Its more than big enough for the wire harness to go through. In the brake compartment, its in the exact same location, just in reverse. Note: for brake compartment, wire harness has to be fished through with a coat hanger and electrical tape because the ABS metal block is in the way to do by hand.

 

sorry dont have any other pix from the install

 

once the wheel well liners were put back, the wheel wells look completely OEM. Everything is covered by the wheel well liner. Also, the battery and the brake compartments look oem as well. Unless you are putting your nose in there and know what you are looking for, one cannot tell that there are wires that are being tucked. Everything looks like its the way it should look from factory.

 

wow looks great!!! :biggthumpu pbiggthumpup:

 

how did u relocate your spark-pplug harness?