stainless steel braided hoses for ARC catch can?
#1
stainless steel braided hoses for ARC catch can?
i need stainless steel braided hoses for my ARC catch can but im not sure on the sizes and lengths.
i want it to be just like Marcus's car.
http://www.anplumbing.com/shop/index...dept=Auto-Flex
or
http://www.holley.com/types/Auto-Flex%20Hose.asp
any help would be greatly appreciated
Thanks,
-Wes
i want it to be just like Marcus's car.
http://www.anplumbing.com/shop/index...dept=Auto-Flex
or
http://www.holley.com/types/Auto-Flex%20Hose.asp
any help would be greatly appreciated
Thanks,
-Wes
#3
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,301
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods
#5
Sorry, taking off my catch can is a hassle, and it's been too cold and dark after work for me to want to do it. I looked at the hoses this morning and they look like -10 and -8. Your best bet is to measure the diameter of the fittings and call up the shop, he'll tell you the right hose diameter size. For the lengths, get some cheap rubber hose from the auto parts store and mock it up... measure, and buy the same lengths in braided hose. This is exactly how I did it on my car.
Unfortunately I can't give you the lengths because it can vary depending on intake pipe, catch can location and routing of the hose.
Good luck-
Unfortunately I can't give you the lengths because it can vary depending on intake pipe, catch can location and routing of the hose.
Good luck-
Last edited by zackt69; 12-10-2009 at 04:39 PM.
#7
Trending Topics
#8
I found this pm I had sent Marcus from way back... not sure if it's right, or if it applies to your setup - but it might be a start.
"You'll need 10ft of -12, and 2ft of -8 hose. The fittings I use are Earl's, and you'll need 3 of the -12 and 2 of the -8 fittings. You only need 3 of the large fittings because you can't see one of the ends... but you can get 4 if you want."
"You'll need 10ft of -12, and 2ft of -8 hose. The fittings I use are Earl's, and you'll need 3 of the -12 and 2 of the -8 fittings. You only need 3 of the large fittings because you can't see one of the ends... but you can get 4 if you want."
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM
Hogbone
Engine, Drivetrain & Forced-Induction
2
09-28-2015 06:44 PM