5/16" Iso Thermal Plenum Spacer Installed, Impressions
Suuuuper duper easy. I thought it was gonna be a bit more involved, but its easy. I used a nutdriver to torque the bolts down (it comes with instructions for this) instead of a tq wrench, so I just used a couple basic hand tools. Make sure you get some break cleaner and a bunch of rags cuz you're gonna want to clean the inside of both plenums and remember to cover the intake holes on the block when you have the manifold off and you should be all good..
Yeah, it'll be all the same. That actually saves you some work. The runners on that lower half are filthy and the cast of that aluminum is crude. Cut my hands a couple times on the edges of it trying to wipe it out.
Hey, you got yours on here right? Did he send you the instructions? If not I can send you mine. You need the bolt tightening diagram.
Yes I got it on here. It was 100% complete minus the coolant bypass valve which I got from another forum member on here as well. Thank you tho
Did you get a CEL tho? Cuz the only reason I had to go the 100 miles was cuz I had to reset the ecu. I didn't feel it at first cuz after the reset my ecu was like, "...dafaq Is goin on..?" And it had to relearn the air/fuel info.



