SeaFoam/Oil Change/TB Clean/Spark Plugs/Possible Oil Catch Can in that order?
#18
It's a Chinese clone of the Nissan Consult 3 hardware device. I can fully run Consult 3 on my laptop and do everything the dealer does. I just can't cut keys or mess with the immobilizer system you need some special add-on cards for that.
#19
Did the cabin filter and cleaned the MAF sensor yesterday. The cabin filter apparently was NEVER changed in the past. After just cleaning the MAF sensor, I can tell the car idles better. I'm still on the fence about the seafoam. I'm waiting for all my parts to come in the mail then I'll see how close I am to needing an oil change.
#20
Did the cabin filter and cleaned the MAF sensor yesterday. The cabin filter apparently was NEVER changed in the past. After just cleaning the MAF sensor, I can tell the car idles better. I'm still on the fence about the seafoam. I'm waiting for all my parts to come in the mail then I'll see how close I am to needing an oil change.
Probably want to change out the rear diff oil also, I think that was a 10MM hex bit if I remember right (I got mine at Home Depot). I'm guessing it's probably black and the magnetic nut is probably gunked up. You also want to buy a pump so you can put the fluid back in. Make sure you remove the top drain plug before the bottom as well. Oh yea wear your MOPP Level 4 gear that **** stinks!
Thread
Thread Starter
Forum
Replies
Last Post
celwin
V36 Engine, Exhaust, Drivetrain & FI
11
09-28-2015 03:52 AM