So after having the new rims on for a week now, I'm noticing that my rear tires are rubbing ever so slightly (mostly when I'm backing out of my drive way). So should I just roll the fenders, run more negative camber, raise the rear up a bit and get a realignment or just live with it?

 

if its only a little and towards the outside of the tire, just roll them.

 

Roll them you'll be greatful that you did later on down the road.

 

i say just roll them fenders

 

Ok so it seems rolling is the answer.

I'm gonna do some searching on it now, but is that a pretty straight forward process? Or would someone want to volunteer some help?

 

roll it !!!! thats what i did

 

How much did it cost to roll yours, I just got a quote of $75 per fender.

 

I can roll a fender in about 15 minutes with a rubber mallot and a heat gun. I wish I could get $75 for both fenders to roll them.

 

How much do you want?

 

We should have a fender rolling party.

 

I concur

 

^fgc master mechanic.

 

Sean does a great job.

He said he'd do both fenders for $75. That's $75 cheaper than the bid you just got and everyone know Sean will do a good job!

Use some of the money you'll save to drive over to Orlando and back...

 

get a rubber mallet !! diy

 

I see.... I misread it. I didn't know he was offering $75 for both fenders, I thought he was just being sarcstic. haha My bad.

I thought it over today and I think I'm just going to raise it up 1/8 of an inch until I have time to make it up to Orlando since I'm going to be really busy this month.

- Saving for a house is starting to cut into my fun time