Anywhere I can get like a 6 or 7 pound spring for a tial BoV this is driving me nuts.

 

Have you considered taking out one of your springs? I did a bit of a writeup here: My Post

 

okay, is the tial a duel spring?

 

I don't know about that one. You might be the first to figure it out.

 

The greddy twins come with the tial wastegates but not with a tial bov im pretty sure.I got my setup from sharif at forged and it came with a greddy rs bov which you can remove one of the springs.

 

Its single spring, what spring do you have in there now?

 

what is the BOV doing??

 

I have a 9PSI spring on like 7 pounds.

I ran against you last weekend you should know

The BoV is just letting VERY little air out, just needs a lighter spring- or ill just turn it up a few pounds when I get the new tranny. =\

 

Thank you for that pearl of wisdom........

 

I don't think they make a 6psi spring, pretty sure the lowest is 7. I think the avg price is almost 30 bucks online, try calling a local performance shop, they might give it to a tiny bit cheaper. They're all over ebay too.

If I were you though, I'd just go with the second route you are contemplating, up the boost a little

 

I made the mistake of getting a 12lb spring and my Tial barely opens. You should be more than fine with the 7lb spring. Thats the lowest spring rate you can get anyway. The springs they provide are dependent on engine vacuum. They recommend a 9 psi spring for the 350z/G35. Turn the boost up and it'll vent.

 

You are very welcome........

 

I found a 7 PSI spring, That should do it =)