I'm sure most of you visit my350z boards but in case you dont:

http://my350z.com/forum/showthread.php?t=323472

 

Must be much more fun to drive !

Could you post the dyno here also ?

 

Sorry, should have done this the first time.


MRC tune of my SC

--------------------------------------------------------------------------------

Well, after finally fixing all of my vortech issues I got myself down to Julian today for a tune on the 3.12 pulley.
My previous best dyno run with the 3.33 pulley was 361hp/316tq. With the 3.12 the best was the last pull of 411hp/352tq. Graph is one of my before runs against today's.
Needless to say I was very surprised. Julian did a great job and the car drives so much smoother. Thanks Julian, see you next year for the TT.





videos:

 

Thanks !
What psi is it running for that power ?

 

Great #'s. When did you do your last dyno? It is winter in NY so colder weather will give you better #'s. Still a very good number!!!

 

Dyno sheet for the psi looks like it's around 9.5. The last dyno was on June 6th. It wasn't too cold in the bay last night, they had the heater going off and on. But I know what your saying, I'm sure the cooler air helped.

 

I had my car also done by Julian last June. Outside temp was 67F-72F and I remember him saying that he can't get a good # coz it was close to 100F inside his shop.

 

^^^^^^^^^ confused !!!!!!

67F-72F outside but 100F in the shop ??????

 

I'm not sure what the temps were outside that day but I'm pretty sure it wasn't 100F inside. I was pulling in the 355 to 370 range that day.

 

I meant around low 70's outside temperature (From the Weather Channel) and his shop for some reason was like an oven... maybe I exaggerated a little