Zex TC Window Switch Question (12V PWR)
#1
Join Date: Aug 2009
Location: Philadelphia, PA
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
Zex TC Window Switch Question (12V PWR)
Question referring to window switch TC wiring diagram on page 4.
http://www.zex.com/Instructions/Files/ZEX169.pdf
In the installation manual, it specifies the power to the TC Window Control unit as +12VDC VD, and then power to the NMU as +12VDC Arming.
My question is can these be drawn off the same +12VDC activated by the arming switch? Not sure why the different designations (VD vs. Arming) and the manual (and tech support) weren't sure what that was either.
I'm an electrical engineer, so yeah, i know 12V is 12V, but i'm more concerned about proper sequencing of the power (i.e. the TCWC has to come up BEFORE the NMU, etc...)
Thanks
Dan
http://www.zex.com/Instructions/Files/ZEX169.pdf
In the installation manual, it specifies the power to the TC Window Control unit as +12VDC VD, and then power to the NMU as +12VDC Arming.
My question is can these be drawn off the same +12VDC activated by the arming switch? Not sure why the different designations (VD vs. Arming) and the manual (and tech support) weren't sure what that was either.
I'm an electrical engineer, so yeah, i know 12V is 12V, but i'm more concerned about proper sequencing of the power (i.e. the TCWC has to come up BEFORE the NMU, etc...)
Thanks
Dan
Thread
Thread Starter
Forum
Replies
Last Post
vstypicals
Buying, Selling & Leasing Discussion
6
07-20-2015 10:55 PM