Cut back of cubby door for gauges?
#16
Not yet. Getting closer though.
Not sure if this is correct.....but I'm mocking up something in Balsa wood first. Then plan on forming a piece of carbon fiber over it. I guess I could research and find a tried and true meathod of creating a plastic/CF piece.....but there are only so many hours in the day.
I did just receive a steering wheel pod that I am going to mount a couple gauges in. Hopefully have those in next week. I'll update then.
Not sure if this is correct.....but I'm mocking up something in Balsa wood first. Then plan on forming a piece of carbon fiber over it. I guess I could research and find a tried and true meathod of creating a plastic/CF piece.....but there are only so many hours in the day.
I did just receive a steering wheel pod that I am going to mount a couple gauges in. Hopefully have those in next week. I'll update then.
Thread
Thread Starter
Forum
Replies
Last Post
djreinx
Engine - Electrical
3
12-10-2015 01:48 AM