Car is the secks... you should get those guys who did the custom plenum to mass produce or atleast sell their plans to those who would want something similar...

 

Haha your car reminded me of the $8 million Maybach Exelero

 

That's how we do it down here in Texas people.

Great job Bryan, can't wait to see the beast in person.

 

We have already discussed this but the demand hasn't quite shown up yet to warrant a run of cast pieces.

 

all back together for now.

 

Craziness man any moar pix?

 

Will have some more up tomorrow. Just grabbed this one from a FastFive premier deal the car was at.

 

if you dont mind me asking... what was the dollar amount for the custom plenum...

 

 

Its done on a quote by quote basis. PM me with what you are wanting to do.

 

Frick man...

I'm an overall FI noob and I have a big build going on- but someone else is doing the work and I depend on their expertise. It's still NOTHING like that... I couldn't even pretend.

Anyway- I have a metric ton of respect for guys like you who truly take our cars to above and beyond. Great work and thanks for sharing the story of your success with that freakish build.

 

Dyno vid from some initial tuning.

 

i want the plenum!! can i have the CNC code lol and also the size of those blanks :P

if they are ever going to produce another one let me know and ill do a full write up for an NA build
I purchased my g about 5 weeks ago and it took me staright research until now to figure out exactly what direction i wanna go ... and then you go and show me that sexy peice of blank that was carved into a picture of jesus's face

 

looking through the picture it looks like there may just be enough room to fit 2 decent sized k&n cones off the bottom of the bends you put leading to the intercooler ... im sure im gonna have to weld in a small bend for each side but thats not a big deal at all .. only problem is i have no ****ing idea where i would put the MAF sensor. probably gonna have to go MAP instead but i am very interested in seeing if the gains are there. the disign is very promising looking.. strangely simlilar to the srt-10 intake manifold but a nicer design as far as plenum goes

 

The plenum on my car is not designed for a NA motor and would most likely loose power if done on a NA car. But one can be made for your setup. The biggest issue is just hood clearance.