Is Infinitiplate.com still around?
#19
I know this was a month ago but I have a question about the Stillen.
By measuring it looks like our '05 sedan is 24mm thread and about 4 1/2-5 inches from the thread mounting surface (the flat area around where the hook goes into if that is the correct place to measure from) to the edge of the fascia surface.
So by the numbers an M35/45 or Sentra kit will work. If it is supposed to be inside the hole then a G37 or 370Z kit will work.
http://www.stillen.com/product.asp?i...EX&r=&b=&m=all
Are my measurements correct regarding what kits will fit our car. We have 3 weeks left to get our tags moved over. The bumper has a recent repaint so Id like to not put holes in it. Plus my wife has a taken an interest in modding her car so she wants it to stay clean and hole free.
By measuring it looks like our '05 sedan is 24mm thread and about 4 1/2-5 inches from the thread mounting surface (the flat area around where the hook goes into if that is the correct place to measure from) to the edge of the fascia surface.
So by the numbers an M35/45 or Sentra kit will work. If it is supposed to be inside the hole then a G37 or 370Z kit will work.
http://www.stillen.com/product.asp?i...EX&r=&b=&m=all
Are my measurements correct regarding what kits will fit our car. We have 3 weeks left to get our tags moved over. The bumper has a recent repaint so Id like to not put holes in it. Plus my wife has a taken an interest in modding her car so she wants it to stay clean and hole free.
#20
Not sure where the measurement is from. I know I purchased the specific kit thats for the 07 G35 Coupe and, after its threaded all the way into the hole, and then after the plate for the tag is attached to that, the plate actually comes into contact with the bumper. I ended up putting a strip of some adhesive rubber gasket type stuff on the edge that touches the bumper to prevent it from scratching it.
Thread
Thread Starter
Forum
Replies
Last Post
BolivianFuego
G35Driver Feedback & Suggestions
4
02-18-2009 08:36 PM