how much does it cost to drill 2 holes?
how much does it cost to drill 2 holes?
hi squad, i just got CF hood,and need to install the hood pins.
wounder if u done drilling the hole in CF for hoodpins any tips will deff help alot, and how much do u think it will cost?.
i went to a shop..qouted me 100 BUUUUUCKs. JUST TO DRILL 2 HOLES?
(i have the hood pins myself,but needed to be install)
wounder if u done drilling the hole in CF for hoodpins any tips will deff help alot, and how much do u think it will cost?.
i went to a shop..qouted me 100 BUUUUUCKs. JUST TO DRILL 2 HOLES?
(i have the hood pins myself,but needed to be install)
It's not that hard. I would install the pins on the rad support and then put grease pen or someting on top of the pin and set the hood down on it to make a mark on the hood. Set the pins as low as possible when you install them for the marking. Then using electrical tape, tape the **** out of it before drilling. Use sharp bits and don't apply a lot of pressure.
Drill up small from the bottom and then move up top for the other drilling as you go bigger on the bit.
Drill up small from the bottom and then move up top for the other drilling as you go bigger on the bit.
Thread
Thread Starter
Forum
Replies
Last Post




