Gialla spoiler install - G35Driver - Infiniti G35 & G37 Forum Discussion

Dec 5, 2003 | 01:15 AM

SoBayG35

Thread Starter

Registered User

Joined: Dec 2003

Posts: 3

Likes: 0

From: Torrance, CA

Gialla spoiler install

I just got my Gialla spoiler, unfortunately the instructions are in Japanese. I can guess on most of the instructions, but I can't figure out how the spoiler attaches to the trunk, since the underside of the spoiler is hollow. Since this is my first mod, and I have to drill holes into my trunk, I do want to be careful. Has anybody installed a Gialla spoiler. I appreciate the help.

G35C MT Pearl

Dec 5, 2003 | 04:00 AM

RaySur350GT

Registered User

Joined: Feb 2003

Posts: 858

Likes: 1

From: Sunny San Diego

Re: Gialla spoiler install

Did it come with a drilling template? If it did, then it will make your job a whole lot easier. If not, I would recommend having it professionally installed.

- Don't argue with idiots. They will bring you down to their level and beat you with experience.=P-

Dec 5, 2003 | 12:15 PM

Loren04Coupe

Guest

Posts: n/a

Re: Gialla spoiler install

Actually, you can see everything in the drawing. The double stick tape strips are 2 different thicknesses. This is listed on the drawing. The double stick tape goes all the ways across the top, the bottom and half way around the sides. They also show you where to drill the 2 holes on the drawing. Just look carefully at your tape strips to make sure you put the right thickness in the right place.

04' G35 Coupe(finally in the garage)
6-sp Diamond Graphite/Willow w/Premium

Dec 5, 2003 | 05:41 PM

SoBayG35

Thread Starter

Registered User

Joined: Dec 2003

Posts: 3

Likes: 0

From: Torrance, CA

Re: Gialla spoiler install

I do see the 2 different type of double stick tape they provide. I can't tell from the drawing, where the holes should be drilled, since they did not provide any drilling template or anything. Do the screws, screw in from the bottom through the trunk, through the thick double stick tape, into the front leading edge of the spoiler? There is not much room for error, when your drilling into the edge of the spoiler. I'd take it to a body shop and get it professionally installed, but I'm sure even they would have a hard time reading the Japanese instructions. Does anybody have any clearer type of instructions? Thanks..

G35C MT Pearl