problem with interior dash lights
Joined: Dec 2006
Posts: 1,312
Likes: 0
From: Eugene,Oregon
problem with interior dash lights
just a few days ago my shift lights has been cut off(the P,R,N,D) , as well with the left heat seat buttom light, is there anything i can do to make those back on?
have a service manual? in the 07's, shows how to do Self-Diagnosis Mode of Combination Meter
SELF-DIAGNOSIS FUNCTION
Odo/trip meter and A/T indicator segments operation can be checked in self-diagnosis mode.
Meters/gauges can be checked in self-diagnosis mode.
OPERATION PROCEDURE
1. Turn ignition switch ON, and switch the odo/trip meter to “trip A” or “trip B”.
NOTE:
If the self-diagnosis function is activated with the “trip A” displayed, only “trip A” display is reset.
2. Turn ignition switch OFF.
3. While pushing the odo/trip meter switch, turn ignition switch ON again.
4. Make sure that the trip meter displays “0000.0”.
5. Push the odo/trip meter switch at least 3 times (within 7 seconds after the ignition switch is turned ON).
6. All the segments on the odo/trip meter and A/T indicator illuminate, and simultaneously the low-fuel warning lamp indicator illuminates. At this time, the unified meter control unit is turned to self-diagnosis mode.
7. Each meter/gauge activates during pressing odo/trip meter
switch. (Then low-fuel warning lamp turns OFF.)
SELF-DIAGNOSIS FUNCTION
Odo/trip meter and A/T indicator segments operation can be checked in self-diagnosis mode.
Meters/gauges can be checked in self-diagnosis mode.
OPERATION PROCEDURE
1. Turn ignition switch ON, and switch the odo/trip meter to “trip A” or “trip B”.
NOTE:
If the self-diagnosis function is activated with the “trip A” displayed, only “trip A” display is reset.
2. Turn ignition switch OFF.
3. While pushing the odo/trip meter switch, turn ignition switch ON again.
4. Make sure that the trip meter displays “0000.0”.
5. Push the odo/trip meter switch at least 3 times (within 7 seconds after the ignition switch is turned ON).
6. All the segments on the odo/trip meter and A/T indicator illuminate, and simultaneously the low-fuel warning lamp indicator illuminates. At this time, the unified meter control unit is turned to self-diagnosis mode.
7. Each meter/gauge activates during pressing odo/trip meter
switch. (Then low-fuel warning lamp turns OFF.)
as to seat heater, if pass seat works, then no a fuse problem nor seat heater relay problem. Does seat still heat and just no light? check under driver seat for loose connector, connects thermostats to heater element.
Thread
Thread Starter
Forum
Replies
Last Post





