Anyone else having an issue with the insert on the rear side interior moulding pulling away? Not sure if it's a heat issue in Florida and the adhesive is wearing out but I'd like to fix it. I'm going to have the sides out next week to install new subs in the rear deck so I thought it would be a good time to take care of it. If anyone has already replaced these do you have the part number? If it's as simple as using the exisiting fabric and more adhesive, let me know that too.

Thanks

 

bump for a little insight.

 

pics?

btw you posted this in the wrong forum...

 

I'll take pics tomorrow. Just thought someone might already know what I'm talking about it.

 

ya mine is pulling out a bit

 

btw you can get the part # from Mike@RiversideInfiniti

 

PIA and looks like sh*t. I'd like to take care of it while I have my sides off to get to my rear speakers. I'll call Riverside tomorrow.

 

Talked to Tony and the fabric inserts are not sold seperately but are part of the inner quarter panel. Looks like I'll get a 3M adhesive spray and see if I can get them back on.

 

mine are the same, look like poo. I'm down to go half on some adhesive to fix it. I seem to restick them and the next time I look their falling again

 

I need to pull the side panels anyway to get to the rear deck speakers so I'll do it while I have them off and let you know how it goes. It would be a major PITA to pull the inner quarter panels just to fix the inserts. I'm pretty sure the South Florida heat has had an affect on the adhesive.