I have the Greddy front bumper as many of you may know and it only is attached by 4 bolts and 6 plastic snaps. It just dosent seem to be fitting properly-specifically right underneatht the headlights. Anybody have advice on how to properly mount the bumper so that it fits better?

 

If theres a gap between the bumper and the bottom of the headlight, then loosen the headlight and move it down a little bit and tighten it back up.

 

not only that but the bumper just isnt sturdy at all. like i can lift it and drop it like an inch with my hand easily.
shouldnt there be more than 4 bolts and snaps holding it on?

(its fiberglass if that matters)

 

can make an aditional mount from the crash bar up to where the grill mounts out of aluminum

 

thanks man...i had that as my last resort, i was just looking for an easier way out.

 

Ya I hear you on that but unfortunatly it is fiberglass and its being stressed at the fender mounts which will eventually crack due to no support in the front.