Hey I'm completely new at modding up a car. I just got my ride a couple months back and after reading up on this site, I'm so interested in replacing my intake...Ztube\PopCharger, Stillen, Nismo CAI...I was just going to do it myself with a DIY printout, but which one would be the best/easiest to install? Is it even a good idea to mess with seeing i have 0 experience with this stuff??

Thanks for any help...

 

Z-tube by far. 30sec to 2minutes top. Do that first, then decide if you want to add the Pop-charger. The Injen and Nismo take some relative handywork. See the DIY in my sig for details.


Black/Willow 03.5 6MT, Premium, Navi, Aero, SAT
350Z Nismo CAI

 

z-tube and pop charger is by far the easiest, i have the aem intake and it took about 1.5 hours installing the system.

 

Hands down, z tube and p/c. Should take you less than 1 hour for both installation.

------------------------
Borla exhaust, Nismo sway bar, Z duct, JWT p/c, Kinetix cats [img]/w3timages/icons/laugh.gif[/img]

 

The Z-tube/JWT PC are definitely a no brainer. The only PITA you might encounter is putting those rubber pieces on the heat shield - takes a lot of patience.

If you decide to go with the Z-Tube and JWT Pop Charger, check out my install - it might help.

My install

04 6MTC DG/G/Prm/NAV/C.Crnrs/C.Br/A.ped/Polk/PIAA/Grnd.Kit/Rebadged/JWT Pop Charger/Z-Tube/Spl.Grds

 

Hey thanks alot guys....Big help....preciate it.

 

When I installed and Intake, for some reason my car at times would go nuts on me. It would sometimes completely shut off and also sometimes you can see the RPM's go up and down and it feels like the car is about to shut off.....Any input???

 

Speedoholic... that's a great install guide... I'm "trying" to keep my car stock and having a hard time resisting... but the engine sounds sweet!!! I'll have to think about it over the weekend and maybe make it a little project on the weekend. =)