I need your help!!!!
My boss gave me a set,(long story) anyway one of our employees had put the wheels back together and mixed up the center piece of the wheels.

the front and rear center pieces are actually different sizes inside where it mounts to the hub.

Just need to know if the bigger ones go in front or back.

http://www.gruppe-s.com/Volk/volksfw.htm

 

I'm confused by your question... If you're referring to wheel width - the wider wheel goes on the back. If you're referring to offset, the general rule is that the lower offset goes on the rear.

IF you're looking to give me some SF winnings that are messed up then I'll gladly take them off your hands!

 

its a tough question to ask ..imma take some pics when I get home that will help explain better.

I know the wider wheel goes in the back, but the center pieces were mismatched when the dumass put em back together after the shop had them refinished

when I had them on my car they seemed to fit fine in the front but right rear side stuck out about an inch wider, I thought it was my cars susp. or something and didnt find out until I took the wheels apart myself and found this dummy had mismatched the center pieces.

hope this story makes sense haha

 

I believe the bigger goes in the rear.

 

this was my feelings at first, but im about 99% sure that when I removed the center pieces that the R Rear was the wheel that stuck out too far and this was the one that was bigger inside.

i called Volk and they were no help .

as of right now a total guess whould be the larger ones go in front and the smaller go in the back but thats a sh** load of bolts that I have to put back in the wheels only to find out im wrong haha

 

Airtools ftw

 

Are the offsets not marked on the center? If not take them apart and put the centers on a flat table (mounting surface down) and the taller ones are the higher offsets and shorter ones would be the lower offset then match up the centers with the corresponding barrel