Hi folks,
My problem is "VDC off" light stays lit when the engine is running.
Pushing the switch does nothing.
I did not touch that plug
The battery was disconnected while I did all the work.
Any clue what I should be looking for?
Thank you

 

my speed sensor was loose one time and caused mine to go off... they located right behind the rotors, can follow line attached to strut to rotor and see if they r loose..

 

vdc is always off? so you dont have to always press that damn button to turn it off? thats awesome! lol

 

I check the speed sensor and there's nothing loose!

 

Check your brakes, that's a common cause of the light being on...

 

I replace my brakes one week ago so i'm sure it's not the problem!

 

so maybe you messed up something when you replaced the brakes? go back re-check everything.

 

i dont know if this could be an answer but I know that me and one of my friends were havin a lil too much fun in our cars doin power slides and such and mine stayed on for a couple days after that, along with the slip light then both went off.. idk wat that was about or if it applies but just my experience

 

Everything worked fine till I unplug the battery. When I change my brakes I didn't unplug the battery....?? Need help!

 

Check your brake fluid level also. I have a leak in my front drivers side caliper somewhere and when it gets too low, those lights all turn on.

 

yea check brake fluid level.

 

Brake fluid seems fine!...

 

what kind of work did you do to the car?

 

I replace my spark plug. So I unplug the connector from the throttle body and every other little connector WITHOUT unpluging the battery. Do you think it might be the problem? Do I need to make a reset of the ECU and do you think Ineed to re-do the throttle learning procedures again?
Let me know
Thanks!

 

yea, shouldn't that be your dreams come true op??