Is there a DIY on this? i need the front quarter panel or is it called the fender of my driver side remove to bend it back into shape.. i tried to search it but couldnt find any.. thank you

 

Pop hood, remove inner fenders lining, locate bolts, remove bolts and pull up and out... shouldnt be much more difficult then that.

 

any idea how many bolts there are? i see 2 near headlamp and 1 near the part where the door is hiding it..

 

In addition to the bolts in the engine bay, there is also one that attaches the fender to the headlamp (remove front bumper to access this one) and also a couple at the bottom of the fender behind the side skirt (you will need to at least partially remove the side skirt to access these).

 

Isnt there some inside the door frame ? How can you get to this without damaging the door? I need to replace my passenger side fender/guard also..

 

Bump? I also plan to tackle this to change my good hinges.

 

1, Remove side skirt (need to undo screws at either end, along the bottom, pull off the infiniti plate inside the door well, the side skirt pulls off
2. There is then two screws the the bottom of the fender that the side skirt covered
3. One screw inside the door jam near the hinge up the top
4. 3-4 screws at the top of the fender inside engine bay
5. one screw that the headlight bolts into on the side