For anyone who has done a paddle shifter install. I'm looking at the Auto-Innovatio kit. Like the looks over the Works-Bell Kit. They provided me with .pdf installation instructions for a 350 Z. (Don't seem to have a .pdf of a G) The paddle kit harness connections are made to a 20 pin connector. Now the question...where is this connector located in a 2003 G. (picture attached) Are the color of the wires the same. I have been searching for a DIY...one had been mentioned in another thread but, i can't find one...tried infinitihelp no luck. Pictures or a video of an install would be greatly appreciated. OK how about this...anybody who has done a double DIN install (or the lever upshift/downshift mod) in an A/T and has had the head unit out. In the added service manual drawing have you seen connector M47 which is listed as the AT device. Is it a 20 pin connector with connections made to the shifter?

 

Wish I could help out there, I am just as interested myself on a DIY paddle shifter install for this kit in particular.

 

Sent you a PM.

 

Got it =)

 

too much work for me

 

Sorry to bring up the dead thread. but I have same question here. After I've read the thread on infinitiscene I've been wanting to do D.I.Y paddle shifter installed.
Did you find where this 20pin connector is located?
And when you wire your paddle shifter to the relay, which on is positive and which one is negative on the paddle itself? Does it matter?

 

link to the diy kit?