ok so i've been doing my own lowering springs install, eibach pro kits. i was putting the struts back in and i'm wanting to know what's the best way to align the fork with the strut cap?

i put mine all back together....only to figure out that the fork didn't align with the cap, but luckily i had the angled part in roughly the right direction, only about 20-30 degrees off....so i had to put the spring compressor back on....then that was in the way of rotating the cap....so i had to take it off again and move it down then compress.......long story short it was a PAIN IN THE ****!!

so is there any way to make sure that stuff is lined up before releasing the spring compressor...other than just eyeballing it....