06 high beam projectors??
#17
#21
So am I.. remember most people will be back there the first time they'll need some room and light to see and get a clear understanding of how the headlamp works. It's the same instructions we give to people installing their HID kits, changing the bulb, adjusting retrofit projectors, etc.. for their first time; jack up the car, turn the wheel, and take off the fender liner and the wheel if necessary.
Once they do one side the next side is cake =)
- Eric
Once they do one side the next side is cake =)
- Eric
#23
Alright so I just went and adjusted them, but for some reason, the left one won't go as low, even though I can keep turning it. I'll go in and examine it tonight when I have time; going to just remove bumper and take the headlights out... Also, both of them are now flickering and not staying on very long T-T I should've just left it on "Blind On-coming Traffic and Disable Same-Flow Traffic Rear View Mirrors" mode.
#24
Make sure your connections are good and that none of the wires are bent too much.. that should stop flickering.
you can also try removing the H4 or H1 Bulb and try to physically reposition/check and make sure it is seated properly against the housing.
Remember you cant aim the lights off the car so try the above methods first.
- Eric
you can also try removing the H4 or H1 Bulb and try to physically reposition/check and make sure it is seated properly against the housing.
Remember you cant aim the lights off the car so try the above methods first.
- Eric
The following users liked this post:
ThatOneDude (08-09-2011)
#25
Fogs flickered and died simply because my battery was dead (yes I'm stupid). Still, the left fog won't aim as low, but I think I remember why now... I managed to drop one of the screws INSIDE of the headlight housing (I spent like 9 years trying to get it out) and now it's jammed somewhere in there; I can't even hear it rattling around. So I settled for just one screw holding the thing in >_____> Thanks for your concern, Eric! I'll post back after my attempts.
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM