OEM Rays 19's on Tein 350z H-Tech Springs. What size wheel spacers would you guys who have already take this route recommend?

 

25f/30r should be about flush. You could also use a ruler and see exactly where you want the wheels to sit.

 

I ran 25 all around with that exact setup and liked it but I would have done 25/30 in retrospect. You may need to roll your rears though, but that's no big deal.

 

Thanks. Any pics??

 

Go with 20/25mm if you don't want to roll fenders. 25/30mm if you can roll the fenders.

 

Not very good ones unfortunately, I haven't had that particular setup for over a year. Here is one where you can see the front, and then some pics of the same spacers, one size up rear tires, on coils.







25 in front are fine without any fender rolling, same with rear until I upped rear tire size

 

25/30

 

And that "upped" tire size is? What was the previous size? Pertinent info possibly?
Skys the limit when it comes to tire sizes for these cars..............

 

What spacers would you need if running 40series tires with coils without having to roll fenders?

 

You should just get the rear fenders rolled. It will make your spacers look 100x better.

 

Depends on the width (offset if not OEM) ..coils don't make a dfference..

 

OEM Rays so 8.0 and 8.5 i think?

 

What is oem sizes 235/35? I think I was like 245/35 or something?? It's been awhile since I was running the rays so I really don't remember and am too lazy to search it up. So just one increase in width, but with 25mm spacers and htechs that caused me to start rubbing until I rolled my rear fenders.

 

OEM rear size is 245/40....or atleast that's what mine is.

 

Thanks right and the front stock size is 225/40

20/25 FTW