how many miles do you guys have on your coupes?
#496
Super Moderator
iTrader: (3)
It pains me to see the resale value on my Coupe as my millage climbs up, but at the same time I'm glad to see it climb. My G is as good as new if not better (could use new front seats) and gets better with every mile. 174k all put on by me with fun memories at every mile. I think I'm going to end up keeping this car for a long time since it does not make sense to sell it for 7k with all the goodies I got on it.
#499
The following users liked this post:
Urbanengineer (03-10-2015)
#500
#502
You can ride one hard and put her away wet, and save the other one for when you want a nice, slow ride and show her off.
If one of them is down for mods, you still have the other one. Ever have to send parts off to the powdercoater? Or mid project and find a part you need to order? Or want to do a long project that is going to have the car down for a while? Always nice to have a spare.
#505
153,389 and she's officially a 1/2 qt. every <500 miles burner absolutely no leaks.... i curse the previous owner for lack of common sense about car maintenance... i love the car reguardless. just purchased:
-front d&p outer tire (tie?) rods
-rear d&p rotors and pads
- front lower d&p control arm bushings and ball joints
- megan racing resonated test pipes (no emissions in my county )
i need to purchase:
-front and rear to subframe differential bushings
- center bearing for driveshaft
-knock sensor and subharness
-rear d&p wheel hubs
and i need my alignment done once suspension parts are installed
eventually i'm getting her painted and tinted but i'd rather fix the repairs first then work on cosmetic fixes.
any suggestions on good part sites that aren't expensive or has anyone purchased any of the parts listed under my need to purchase list and have advice/info they could give me. thanks in advance!!!
-allie
-front d&p outer tire (tie?) rods
-rear d&p rotors and pads
- front lower d&p control arm bushings and ball joints
- megan racing resonated test pipes (no emissions in my county )
i need to purchase:
-front and rear to subframe differential bushings
- center bearing for driveshaft
-knock sensor and subharness
-rear d&p wheel hubs
and i need my alignment done once suspension parts are installed
eventually i'm getting her painted and tinted but i'd rather fix the repairs first then work on cosmetic fixes.
any suggestions on good part sites that aren't expensive or has anyone purchased any of the parts listed under my need to purchase list and have advice/info they could give me. thanks in advance!!!
-allie
#506
#507