Coupe: Poly Inven Front vs Poly Kuruma Z
Joined: Aug 2008
Posts: 38
Likes: 0
From: Sacramento, CA
Coupe: Poly Inven Front vs Poly Kuruma Z
Hey guys,
Quick question...I am deciding on a front bumper and can't decide between these two. My sides are going to be Impul or Ings.
My main question is, how many inches or how much lower are these two bumpers vs the stock bumper?
Thanks
Quick question...I am deciding on a front bumper and can't decide between these two. My sides are going to be Impul or Ings.
My main question is, how many inches or how much lower are these two bumpers vs the stock bumper?
Thanks
Did you decide between the two yet? Surprised no comments yet! I am in the same situation as you, debating between a Karuma Z or the Inven, my 04 G coupe is black, any suggestions? I personally like the Inven because it keeps that infiniti style with the two larger "cut-outs". Mine is also a daily driver at this point not sure if one is much lower than the other. I have a chargespeed rear bumper and plan on putting on impul SS. Thanks.
kuruma is lower than the inven - and by a noticeable amount too. impul and ings are two of the lowest hanging sides too - so the kuruma will match up closer to ground height than the inven if that matters to you. I personally hate difference in ground heights between bumpers and sides, so I went with kuruma and impul - and even then, impuls are 3/16" lower than the kuruma.
dont go w/kuruma. everyone and their mother runs kuruma and impuls.. be unique and not cookie cutter.
**dont get me wrong, it looks good but seeing it too often...
**dont get me wrong, it looks good but seeing it too often...
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Z1Motorsports
Suspension-Vendor
56
May 31, 2020 01:56 PM
FS[SoEast]: 2006 DG Coupe Part Out - mrev2, projectors, etc
bu villain
Accessories
63
Aug 25, 2016 07:14 PM




