cnc short shifter knob removal
#1
#2
If your car is a 6MT, which is sounds like it is given that your **** is twist on/off, you need to pop up the plastic trim piece that constitutes the lower part of the center console (ash tray + shifter area). It pops up pretty easily.
Then, you need to grab a hold of the shift lever with a pair of vise grips or pliers prior to spinning off the ****. The reason is that if your shift **** is screwed on tightly, you might twist the entire shifter assembly and unscrew it from where it attaches to the tranny, which would not be good.
Then, you need to grab a hold of the shift lever with a pair of vise grips or pliers prior to spinning off the ****. The reason is that if your shift **** is screwed on tightly, you might twist the entire shifter assembly and unscrew it from where it attaches to the tranny, which would not be good.
Thread
Thread Starter
Forum
Replies
Last Post
Freeman186
Engine, Drivetrain & Forced-Induction
1
09-06-2023 10:07 AM
Danielek
G35 Sedan V35 2003-06
9
05-01-2022 01:28 PM
Thebaws11
G35 Coupe V35 2003 - 07
8
11-30-2016 12:54 PM