Hey so hopefully I can find someone here that knows anything about this issue of mine. I have an engine that’s been rebuilt( only about 900ish miles on it) well I’ve changed the oil in it around 400-500 miles and here recently noticed a small oil leak on my pan and was going to re seal my pan. While draining and pulling the pan off I noticed small bits of saw tooth like metal shavings in the oil? Anyone know what I need to look into next or do I currently plan to contact the engine shop Monday that I took it too if I have not figured this out by then. Again any help will be more then appreciated because I am just trying to figure out how bad this is and what it is, thanks.

 

Pictures pictures pictures.

 

Dude if you got warranty I'd take it right back, 900 miles on motor and already seeing metal, na something aint jiving.

 

Yeah something ate itself up, motor is probably shot.

 

Do a compression test!
If all cylinders are normal just run it till it dies.
Carry a screwdriver with you so you can remove your plates when the death occurs.
If your engine was rebuilt where were the parts/rings obtained from? If China that may explain?