pulled and rolled fender?
#7
Trending Topics
#8
Originally Posted by soyusause
oo cause im going deep dish i getting an 5 inch lip 19 by 10
Care to share the offset. Either you are making some major mods to the car or that is one curved spoke wheel. The largest I have had so far is ~3.5" with a 20x10 +40, rolled fenders and some negative camber. You can go lower but it will take a lot of negative camber and a big stretch on your tires.
#9
#10
Originally Posted by soyusause
idk the offset yet cause idk if i want to roll and pull my fender. the shop im gonig to they gonig to do all the math and stuff to get the right off set so i can run a fat lip. i might run an 19 by 9 but with an low disk so i can get a fat lip as an 10 inch
Even if you stretched the tires, ran -2.5 degrees of camber, rolled and pulled the fender, you'd only be able to get around a +15 on a 19x10 which would give you around a 4-4.5" lip.
-GP-
#12
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM
Ninjay16
Audio/Video/Electronics
11
02-26-2018 06:14 PM